Installation of your custom blinds and canvases

Installation horizontal blinds

INSTALLING YOUR BLINDS IS EASY!

INSTRUCTIONS

HORIZONTAL BLINDS

All of our blinds are super easy to install, you can simply do it yourself.

INSTALLING END BRACKETS

  1. Determine where to attach each bracket
  2. For outside mounting (A), position the bracket on the window frame or wall and attach with the proper fasteners
  3. For inside mounting (B), position top of bracket against inside surface of window frame and attach as shown (each end bracket uses two screws mounted diagonally)
  4. Make sure end brackets are level.
INSTALLING END BRACKETS

INSTALLING SUPPORT BRACKETS

(supplied with the blind)
  1. Center the support bracket between the two end brackets
  2. Keep the top and back of each support bracket level and aligned with the tops and backs of the end brackets
  3. If more than one support bracket is used, space the support brackets evenly across the width of the headrail (C)
  4. Insert screws in the back for an outside mount (C1)
INSTALLING SUPPORT BRACKETS

INSTALL THE HEADRAIL

  1. Slide the headrail into the end brackets and center support (C)
  2. Then close end bracket covers until they click into place (D) INSTALL THE VALANCE
INSTALL THE HEADRAIL

INSTALL THE VALANCE

  1. Your blind includes a valance
  2. Position one valance clip at each end of the headrail and evenly space any additional clips across the width of the headrail
  3. Snap channel onto clips as shown (E)
INSTALL THE VALANCE

HOW TO OPERATE

(Tilt)

Turn the wand to the left or the right to adjust the slats to your desired position.

HOW TO OPERATE TILT

HOW TO OPERATE

(Lift Option)

IMPORTANT: Operating & Care Instructions for Cordless Blinds READ CAREFULLY

  1. Always rotate the slats to the "open" horizontal position before raising or lowering. This assures smooth operation and increases the life of the blind.
  2. To maintain optimal performance of the springs that make your cordless blind function, lift and lower your blind through its full range of motion - all the way up and all the way down - as frequently as possible.
  3. Always raise and lower the blind SLOWLY to assure that the slats stack neatly. To lower the shade: grip the bottom rail with both hands and slowly pull straight down. To raise the shade, put both hands under the bottom rail and push up slowly.
To lower the blind:
  1. Pull down on the bottom rail with one hand gripping it near the middle or with both hands grabbing the bottom rail at the equal distance from the center. Once released, shade will stay in place at desired height.
To raise the blind:
  1. Push up on the bottom rail near the center to reach desired height. Once released, shade will stay in place.
  2. Always keep the bottom rail level
HOW TO OPERATE LIFT

ADVICE FOR YOUR WINDOW COVERING INSTALLATION

Loading...
Popup6
Popup7
Popup8
Popup9
Popup10
Popup12